A fitting for a vacuum pump inlet.
Special "Y" fitting for 1/4 & 3/8 inch tubes
This is a contact holder for high power switch equipment.
This is a contact holder for high power switch gear.
Oversized Torsion Bar Linkage
A liquid level sight glass for a high vacuum diffusion pump. Every piece on this order was leak checked and guaranteed to leak less than 1x10 -9 std.cc/sec. He. (This is equivalent to approximately 1 cubic inch of air leaking across at a one atmosphere differential over a period of 1000 years.)
The bottom part, a flange, is attached with a clam-shell clamp to the pump. The rounded barbs accept up to .25" (6.4mm) I.D. soft tubing.
that lock a periscope in place on a tank. Rather than making a mold and a hard-to-fix casting a single large disc was cast and the levers were machined from the solid
The part on the right is made from a casting. The part on the left is made from a 1.25" x 2" aluminum extrusion. The left hand part is both better and cheaper."
